Kia EV Forum banner

Wrapping accent trim advice for black EV6

4K views 11 replies 7 participants last post by  benja455 
#1 ·
I want to wrap the silver trim on the Wind but wanted to try something different than just black. I also plan on wrapping the wheels and logo black but haven't gotten to it yet.

I don't like my first attempt. Looks a bit too much red.
Wheel Tire Car Automotive parking light Vehicle



So my question is should I leave some red or just murder it?


Photoshop leaving a bit of red:
Wheel Automotive parking light Tire Car Vehicle


Photoshop of murder:
Wheel Automotive parking light Tire Car Vehicle
 
See less See more
3
#10 ·
I pre-wrapped the ends (the triangle shape ends). I used 1" strip to wrap each section. I lined up the top, knifed the bottom and also knifed the excess ends. The bend wasn't so bad that I was just able to stretch the wrap a bit w/o using any heat.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top